The best smart protection for your pick up truck Pickup trucks are the most versatile and popular vehicles on the planet. But let’s face it: Anything you throw in the bed will damage the factory finish. It’s as simple as realizing that your truck bed has the same finish as the rest of your truck. I’m sure you wouldn’t put a toolbox on the hood—it will scratch it. So why not protect the truck bed from unnecessary damage?
|No Lost Cargo Space|
|Prevent Rust & Corrosion|
|Bonds and Dries|
|Scratch And Dent Resistant|
|Dampen Sound and Vibration|
Applied directly to your truck bed, TOFF sprayed on bed liners form a permanent watertight bond between the vehicle and the outside environment, protecting it from corrosion, rust, scratches, scrapes, and dents. It adheres directly to every curve and contour of your vehicle and creates a non-skid surface that holds loads in place.
It works just as well on used vehicles to increase the resale value as on new vehicles to keep them in mint condition.
TOFF is a two component, modified polyurea elastomer coating that, when applied, becomes solid is seconds. Once applied, TOFF creates a water tight seal to the bed, protecting it from wear, corrosion, and impact while enhancing the appearance of the vehicle.
TOFF is sprayed-on new and used trucks in dealerships across the country. Truck accessory shops and collision centers also spray TOFF for large and small projects.
We also apply TOFF to boats and jet skis: 100% Waterproof, up to 500% elongation, high resistance to wear and impact, bacteriologically stable, applicable on almost any interior or exterior surfaces, resistant to fuels.
The bed is draped in plastic and masked off to protect the areas of your truck that will not be sprayed. Fiber tape is embedded to create clean cuts after application. The bed is thoroughly abraded to create the proper adhesion of the bedliner. Finally, the bed is air blown and wiped down with a specialty cleaner to remove any loose particles.
TOFF is consistently sprayed over the entire truck bed for an air and water tight seal. It dries almost instantly and is ready for use immediately.
The pre-embedded fiber trim is pulled through the liner material, yielding a clean, straight, edge. All other plastic and masking is removed and any excess liner material is carefully removed. The result is a factory installed look that will protect your truck.